Using Natural, Non-Toxic Ingredients to Clean Your Bong

Keeping your bong clean is an important part of preserving its lifespan. If you’re looking for an easy and natural way to clean your bong, vinegar and salt are two key ingredients that can help get the job done. In this article, we’ll show you how to clean a bongand salt to give your bong a thorough cleaning.

To begin, start by filling your bong with a mixture of one part vinegar and two parts warm water. Fill the bong to within an inch or two of the top. Let the mixture sit for about 10 minutes so that it can really break down and dissolve any built up residue. Once this is done, add a tablespoon of salt to the mixture and let it sit for another 10 minutes.

After the salt has had a chance to work its magic, use a bottle brush or pipe cleaner to scrub the sides of your bong. This will help break up any stubborn residue that may have built up over time. Make sure you get into all the nooks and crannies so that all the gunk is removed.After you’ve scrubbed your bong, it’s time to rinse. Use warm water to flush out any remaining vinegar and salt mixture from your bong. Make sure you get into every corner of the piece and really clean it out before drying.

Soak the Bong in Vinegar

The first step is to fill up your sink with enough hot water to fully submerge your bong. Then, pour in some white vinegar—roughly ⅓ cup per gallon of water should be enough. Let the bong soak for about 15 minutes, then use a pipe cleaner or cotton swab dipped in the mixture to scrub away any remaining residue on the inside of the chamber. After that, rinse it off with hot water and let it air dry.

Use Salt for Tough Residue

If you’re still struggling with stubborn residue after soaking your bong in vinegar, try adding some coarse salt into the mix. This will help break down even the most hardened debris without damaging or scratching your glassware. Fill up a resealable baggie with equal parts salt and white vinegar, then drop in your bong pieces and seal it up tightly. Shake it around vigorously for a few minutes before rinsing off with warm water and letting them air dry again.

Repeat as Necessary

Depending on how often you use your bong, you may need to repeat these steps as frequently as once every few weeks or so. If you find yourself needing to do deep cleans more often than not, consider investing in a specialty cleaning solution like Formula 420 or alcohol-based cleaners like Isopropyl 99%. These solutions are specifically designed for glassware and will make short work of any stubborn residue buildup on the inside of your chamber walls.

Cleaning your bong doesn’t have to be complicated—vinegar and salt are all you need! These two simple ingredients can instantly dissolve tough residue buildup on even the dirtiest of glassware pieces without damaging them in any way. For best results, just remember to rinse off all traces of the vinegar solution after each use and never leave it sitting overnight; otherwise, it could cause permanent discoloration or corrosion over time! With this method, you’ll have crystal clear glass ready for another smoking session in no time at all!

You Might Also Like

Back to top